Tunze Turbelle® nanostream® 6095
TUNZE® HUB EDITION
WIDE FLOW
For aquariums from 100 to 1,000 liters (25 to 265 USgal.).
Flow rate: 2,000 to about 9,500 l/h (550 to about 2,500 USgal./h) with Turbelle® Controller
Energy consumption: 5 - 21 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø50/10 mm (2/.4”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).
TUNZE® HUB EDITION
The TUNZE® HUB EDITION pumps can be controlled electronically and have been provided with a fish-care function. These pumps are equipped with the Turbelle® Controller 7020 to adjust the pump performance and for access to the TUNZE® HUB. Using this cloud solution, many devices from TUNZE® and other manufacturers can be clearly controlled and regulated via WiFi and the Internet. An integrated real-time clock prevents time shifts due to power failure.
nanostream® design
Turbelle® nanostream® electronic are speed-controlled pumps with a Turbelle® controller operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to >1,000 liters (10 to >265 USgal.) for simulation of lapping waves or tidal currents. They contain a microprocessor-controlled motor and a Turbelle® controller. The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill.
Apart from that, the pumps can also connect to devices controlled by the SmartController via the TUNZE® HUB.
Safety extra-low voltage, blocking and...
run-dry protection.
