Milwaukee MC310 EC Conductivity Monitor.
The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.
All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.
Professional EC - Conductivity Monitor
- User selectable Hi/Low Set Point
- Manual 1 point calibration
- Visual LED alarm
- Supplied with 12 VDC adapter, mounting kit, and 20ml 1413 µS/cm calibration solution
- MA811/2 EC Conductivity Probe with 2m cable (BNC connector)
Milwaukee MC310 EC Conductivity Monitor.
The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.
All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.
Professional EC - Conductivity Monitor
- User selectable Hi/Low Set Point
- Manual 1 point calibration
- Visual LED alarm
- Supplied with 12 VDC adapter, mounting kit, and 20ml 1413 µS/cm calibration solution
- MA811/2 EC Conductivity Probe with 2m cable (BNC connector)
| SPECIFICATIONS | |
| Range | 0.0 - 10.0 mS |
| Resolution | 0.1 mS/cm |
| Accuracy | ±2% Full Scale |
| Setpoint range |
1 - 5 mS |
| Alarm | Active when reading is higher or lower than set point |
| Probe | MA812/2 (included) |
Item No. TE-MC310
